My Account
Cart (
(
Portable License for KaliBronek is an innovative solution to not-simultaneous use KaliBronek on many computers. Instead of using expensive hardware keys (HASP) you can use a USB memory stick (PenDrive).
How does it work?
To create portable license you can use any USB flash drive. The license is created by using special software provided by GeoX. When you create a license, the necessary information is stored in folder “GeoX” on the removable disk. Then just install KaliBronek on any number of computers. From that moment on, you can use KaliBronek at any computer, if is connected to a computer flash drive with a license.
Limitations
You can not change the contents of a folder “GeoX” on the Flash Drive, or delete it, there can also be formatted pen drive. Performing any one of these activities involves the mobile license reactivation.
For more information:
KaliBronek page
Posts in this category
Adjustment points in ...
28/08/2023
2 min
28/08/2023
2 min
Adjustment points in quick drawing of the grid
Click to Start Warp "with quick drawing of the grid" on the Warp tab. In...
Read more
TFW – problems ...
28/08/2023
< 1 min
28/08/2023
< 1 min
TFW – problems with georeferencing files
Some versions of IntelliCAD allow the insertion of a georeferenced raster without using KaliBro. The...
Read more
Defining adjustment p...
28/08/2023
2 min
28/08/2023
2 min
Defining adjustment points with lines
Select any drawing layer and set the desired parameters for the lines to be drawn....
Read more
Editing of adjustment...
28/08/2023
2 min
28/08/2023
2 min
Editing of adjustment points
The editable table on the Warp tab (full view) shows all adjustment points. All loaded...
Read more
Problems with retaini...
28/08/2023
2 min
28/08/2023
2 min
Problems with retaining the current position ar...
On the OPTIONS tab select COMPASS SETUP. If the current position arrow or compass is...
Read more
Featured posts
28/08/2023
2 min
Adjustment points in quick drawing of the grid
Click to Start Warp "with quick drawing of the grid"...
Read more
28/08/2023
< 1 min
TFW – problems with georeferencing files
Some versions of IntelliCAD allow the insertion of a georeferenced...
Read more
28/08/2023
2 min
Defining adjustment points with lines
Select any drawing layer and set the desired parameters for...
Read more
